Juniper CTP2000 Series Hardware Manual page 104

CAUTION:
the CompactFlash card might become corrupted.
To remove a CTP module:
1. Issue the halt command.
2. Ground yourself by using an antistatic wrist strap or other device, and connect it to an ESD grounding
jack, if available, or another grounding device.
3. Use a Philips screwdriver to loosen the captive screws located at the top and bottom of the module
panel.
4. If the module has ejector handles, press the red release buttons, and pull the ejector handles outward
to the open position.
5. Carefully slide the module out of the chassis.
6. Place the module in its antistatic bag, being careful not to touch module components, pins, leads or
solder connections.
7. Cover the empty chassis slot with a blank filler panel, and tighten the filler panel's captive screws using
a Phillips screwdriver. Turn both screws several times before tightening them completely.
RELATED DOCUMENTATION
Installing a CTP Interface Module, Processor Module, or Clock Module | 95
CTP2000 T1/E1 Interface Module | 13
CTP2000 Clock Interface Modules | 27
Cabling the CTP2000 Platform Overview | 108
T1/E1 Interface Module Pinouts | 51
If you do not use the halt command before powering down the CTP device,
97