Toshiba PNE001Z Function Manual page 18

Communi
Title
cation No.
C100
c100
Inverter operation at the
C101
c101
communication loss action
Preset speed operation
C102
c102
selection
Communication time-out
C103
c103
condition selection
C154
c154 PROFIdrive JOG1 frequency
C155
c155 PROFIdrive JOG2 frequency
C156
c156 PROFIdrive Tmax
C157
c157 PROFIdrive Tolerance
C504 IP mode (*1)
c504
C505-
c505-
IP address (*1)
C508
c508
C509-
c509-
Subnet Mask (*1)
C512
c512
C513-
c513-
Gateway address (*1)
C516
c516
C554
c554
(*1): These parameters are affected after reset.
Function
Communication error detection
delay time
Web service (*1)
Description
0.0 - 100.0 sec.
The waiting time of network error detection can be
adjusted. If a network error continues past the time
set in c100, it is recognized as a communication
error, and inverter will operate according the setting
of c101. If network error was removed during
c100, inverter will continue normal operation.
0: Stop and controlled by cmod, fmod
1: Operation continue
2: Deceleration stop
3: Coast stop
4: Network error stop (err8 trip)
5: Preset speed operation (by c102 setting)
0: None
1 to 15: Preset speed
The operation frequency when the communication
fault is occurred can be selected from preset
speed. (Only when c101 is set to 5)
0: Disconnection detection
1: When communication mode enable (Both
cmod and fmod are set CANopen or
communication option) only
2: 1 + Driving operation
0.0 to 20.0Hz
0.0 to 20.0Hz
0.1 to 60.0s
0.1 to 99.0%
Use this parameter to select the IP address
assignment method.
0: Manual
1:Invalid setting
2: DHCP
3: DCP
The IP address of the option module.
These fields are effective settings at c504 = 0.
The subnet mask of the option module.
These fields are effective settings at c504 = 0.
The gateway IP address of the option module.
These fields are effective settings at c504 = 0.
Enables web server.
0: Disable
1: Enable
- 15 -
E6582051
Default
setting
0.0
4
0
1
5.0Hz
5.0Hz
10.0s
50.0%
0
0.0.0.0
0.0.0.0
0.0.0.0
1