Table of Contents
Advertisement
8 Operating Procedures
8.1 SCC Controller and Rectifier Module
For operation instructions on these units, refer to the following documents.
•
SCC Controller Instructions (UM1M520HNA)
•
Rectifier Module Instructions (UM1R123000)
Expected Number of Rectifiers
You can set the number of rectifiers expected to be in the system via the controller. If the controller does not find the specified
number of rectifiers, the controller will send an SNMP trap to notify the RMS.
Detailed Status for Rectifiers
When a yellow or red LED is illuminated on a rectifier, the SNMP data from the controller can be used to identify the specific problem.
8.2 Local Indicators
SCC Controller and Rectifier Module
Refer to the separate instruction documents for descriptions of the local indicators located on these units.
9 Maintenance
9.1 System Maintenance Procedures
It is recommended to perform the maintenance procedures listed in Table 9-1 every 6-months to ensure continual system operation.
Table 9-1: Maintenance Procedures to be Performed at 6-Month Intervals
PROCEDURE
Check ventilation openings for obstructions such as dust, papers,
manuals, etc.
Inspect and tighten all installer's connections
Vertiv™ NetSure™ ITS Series +12V DC Power Shelf Installation & User Manual
REFERENCED IN
--
Making Electrical Connections section of this document.
25
Advertisement
Table of Contents
