F3-Design NIPPER Installation Instructions Manual page 43

Too close to destination
batt. voltage state
batt. sync state
batt. flash data state
batt. ram data state
batt. flash state
batt. bus time
batt. overcurrent
discharge
batt. short circut
discharge
batt. overvoltage
batt. undervoltage
batt. temperature
batt. undertemp charging
batt. communication
batt. EEPROM
batt. voltage low (20%)
batt. voltage low (10%)
batt. voltage low (5%)
mover is not charging
Partner mover is not
charging
battery balancing timeout
moved while changing op
mode
battery overcurrent
lagless axis front left
lagless axis front right
lagless axis rear left
lagless axis rear right
max torque border
pump axis fault
Error prot. field angle rear
timeout closing valve
lift timeout
INSTALLATION INSTRUCTIONS NIPPER - JULY 2020
- Vehicle is too close to the
destination
- Battery hardware defect
- Battery hardware defect
- Battery hardware defect
- Battery hardware defect
- Battery hardware defect
- Battery hardware defect
- Battery hardware defect
- Short circuit of the battery
- Overvoltage through defective
charging station
- Undervoltage through storage
- Charging station defective
- Under-/Overtemperature
due to improper handling
- Minimum operating
temperature undershoot
- Battery hardware defect
- Battery hardware defect
- Battery level low
- Battery level low
- Battery level very low
- Battery ist not charging
- Battery ist not charging
- Battery hardware defect
- Changing operation mode
failed
- Overcurrent battery
- Vehicle dirty
- Contouring error through
pollution
- Contouring error through
pollution
- Contouring error through
pollution
- Contouring error through
pollution
- Torque monitoring becomes
active
- Error hydraulic unit
- Activation laser scanner failed
- Hydraulic valve not closed
- Dirty
- Oil level too low
- Wrong oil
- Check the layout
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Contact the manufacturer
- Renew charging station
- Charge the device
- Wait until the device has heated/cooled
- Operate within the allowed temperature
areas
- Contact the manufacturer
- Contact the manufacturer
- Charge the device
- Charge the device
- Charge the device
- Check charging contacts
- Check functionality of charging station
- Check charging contacts
- Check functionality of charging station
- Contact the manufacturer
- Check that the vehicle is not moving while
changing
- Clean device
- Clean device
- Check ground conditions
- Clean device
- Check ground conditions
- Clean device
- Check ground conditions
- Clean device
- Check ground conditions
- Check ground
- Clean device
- Check tank ventilation
- Contact the manufacturer
- Clean the laser scanner
- Contact the manufacturer
- Clean device
- Check oil level
43