Versions; Additional Fittings - Samson 3256 Mounting And Operating Instructions

3.2 Versions

With insulating section/bellows seal
The modular design allows an insulating sec-
tion or bellows seal to be fitted to the stan-
dard valve version.
Trims
Flow dividers (u T 8081) can be used to re-
duce the noise emission.
AC trims (u T 8082 and u T 8083) can be
used for low-noise pressure letdown of liq-
uids.
Perforated plugs (u T 8086) can be used to
handle critical medium states (e.g. saturated
steam).
Ceramic trim parts (u T 8071) can be used
when the valve is subject to considerable
erosion and abrasion (e.g. through flashing
service and in applications involving corro-
sive media containing solid particles).
Actuators
In these instructions, the preferable combina-
tion with a SAMSON Type 3271 or
Type 3277 Pneumatic Actuator is described.
The pneumatic actuator (with or without
handwheel) can be replaced by another
pneumatic actuator in a different size, but
with the same travel.
Î Observe the maximum permissible actu-
ator force.
Note
If the travel range of the actuator is larger
than the travel range of the valve, the spring
assembly in the actuator must be preloaded
EB 8065 EN
Design and principle of operation
so that the travel ranges match. See associ-
ated actuator documentation.
The basic pneumatic actuator can be re-
placed by a pneumatic actuator with addi-
tional handwheel or by an electric actuator.

3.3 Additional fittings

Strainers
We recommend installing a SAMSON
strainer upstream of the valve. It prevents
solid particles in the process medium from
damaging the valve.
Bypass and shut-off valves
We recommend installing a shut-off valve
both upstream of the strainer and down-
stream of the valve and installing a bypass
line. The bypass ensures that the plant does
not need to be shut down for service and re-
pair work on the valve.
Insulation
Control valves can be insulated to reduce
heat energy transfer.
Refer to the instructions in the 'Installation'
section.
Test connection
Versions with bellows seal fitted with a test
connection (G
) at the top flange allow the
1 /
8
sealing ability of the bellows to be moni-
tored.
Particularly for liquids and vapors, we rec-
ommend installing a suitable leakage indica-
tor (e.g. a contact pressure gauge, an outlet
to an open vessel or an inspection glass).
3-3