BAYKON BX11 Series User Manual page 35

Parallel Outputs
Access to the parameter [904]. The prompt [o X Y] appears on the display.
To perform parallel output test, enter the number of parallel output to Y digits via < Zero >
key. To change the logical condition of that output via < Tare > key and X shows the logical
condition of that output.
Load cell output level in mV
Measuring load cell signal value is very difficult after installation the system. You can
measure the load cell signal value at parameter [905] without disconnecting the load cell
connector.
BX11 Smart Process Indicator, User Manual, Rev. 1.8, May 2017
Page 33 of 48