BAYKON BX11 Series User Manual page 31

Analogue Output ( Only BX11 AN )
The calibration of the analogue output is performed automatically after calibration the scale. If you
want to adjust the analog output manually access to the parameters below as seen at the in the
programming parameters flow diagram ( Page 24 ) and follow the descriptions below.
[410] Coarse Zero Adjustment
Press < Zero > key one after another to increase the analogue signal level or press
< Tare > key to decrease the analogue signal level.
[411] Fine Zero Adjustment
Press < Zero > key continuously one after another to increase the analogue signal level or
press < Tare > key to decrease the analogue signal level.
[420] Coarse Span Adjustment
Press < Zero > key continuously one after another to increase the analogue signal level or
press < Tare > key to decrease the analogue signal level by taking the full capacity value
as reference without placing any weight.
[421] Fine Span Adjustment
Press < Zero > key continuously one after another to increase the analogue signal level or
press < Tare > key to decrease the analogue signal level by taking the full capacity value as
reference without placing any weight.
[440] Zero Adjustment with Coefficient
This Coefficient will be determined the zero point of the analogue signal level. Enter the new
value via < Tare > and < Zero > keys and press < Enter > key to go to the next step.
[441] Gain Adjustment with Coefficient
This Coefficient will be determined the span point of the analogue signal level. Enter the new
value via < Tare > and < Zero > keys and press < Enter > key to go to the next step.
[13- ] Parallel Inputs and Outputs
BX11 has an optional up to 4 parallel inputs and up to 5 parallel outputs.
[130 0 ] Outputs
The outputs operate with respect to the weight value seen on the display.
BX11 Smart Process Indicator, User Manual, Rev. 1.8, May 2017
Page 29 of 48