Table of Contents
Advertisement
B
Installing an IP AutoSwitch
Follow these steps to add an IP AutoSwitch
(KVH part no. 72-0634) to each DISH Network,
Bell TV, or linear receiver you want to be able to
control satellite selection in Automatic satellite
switching mode.
NOTE: A receiver connected directly to the TV-Hub's
"Receiver" jack can control satellite selection without
an IP AutoSwitch.
Inspect Parts
Follow these steps to inspect the kit contents.
1. Unpack the box and ensure it contains
each of the following items:
• 3 ft (1 m) Ethernet cable
• 2 ft (60 cm) RF cable
• 1.3 ft (40 cm) RF cable
• 22 KHz tone blocker
• Adhesive-backed Velcro strip
2. Carefully examine all of the supplied
parts to ensure nothing was damaged
in shipment.
3. Locate the serial number on the
bottom of the IP AutoSwitch (see
Figure 70) and record it on the
Installation Checklist (supplied in the
Welcome Kit) for future reference.
Choose a Mounting Location
Choose a mounting location that meets the
following requirements:
• Dry, well-ventilated, and away from heat
sources
• Provides a clear view of and easy access to
the Master Select button (see Figure 70)
• Provides adequate clearance for running the
cables and allows for service loops and strain
relief
• Within 2 ft (60 cm) of the associated receiver
in order to use the supplied cable
• Either a horizontal or vertical surface
Figure 69: IP AutoSwitch
Figure 70: Serial Number and Master Select Button
Serial Number
Appendix
Master Select Button
41
Advertisement
Table of Contents
