Table of Contents
Advertisement
C
Continued
10. Add the new receivers to the
Autoswitch page of the web interface.
Enter each receiver's static IP address
and assign it a friendly name (e.g.,
"Salon") (see Figure 81).
IMPORTANT!
Be sure to enable external device access, as
directed by the TV-Hub's Setup Wizard. If the
TV-Hub is then unable to communicate with
the receiver, try resetting the receiver (press
its red reset button or unplug it, wait 15
seconds, then plug it back in and turn it on).
Using a DIRECTV Coax Network
Figure 81: Adding a DIRECTV Receiver to the Autoswitch Page
49
Advertisement
Table of Contents
