Table of Contents
Advertisement
14
Turn On the System
Follow these steps to turn on the system for the
first time.
a. Ensure the antenna has a clear, unobstructed
view of the sky.
b. Press the power switch on the rear panel of
the TV-Hub to apply power to the TracVision
system (see Figure 46).
IMPORTANT!
During startup, the TV-Hub checks the
software versions installed in the antenna and
updates them if necessary to match the
versions it has stored for that model. All three
status lights (see Figure 47) will alternate
orange while this update is in progress. Do
not turn off the system during this time.
Updates might take up to 40 minutes.
c. Within a few minutes, the TV-Hub and
Power lights should be lit green (the Antenna
light will be flashing green).
d. Plug in and turn on any connected receivers,
DVRs, and televisions.
Figure 46: TV-Hub Power Switch
Power Switch
Wi-Fi
NMEA 2000
DC IN
LEN=1
10-30V
NMEA 0183
MAX CURRENT 9.5A
B
POWER
TV-Hub
Figure 47: TV-Hub Status Lights
TV-Hub Antenna Power
FUSE
DSWM
ETHERNET
RECEIVER
ANTENNA
GROUND
RESET
A
29
Advertisement
Table of Contents
