Table of Contents
Advertisement
11
Continued
Sky Mexico Wiring
Follow these steps to connect Sky Mexico
receivers to the TracVision system.
NOTE: The Sky Mexico LNB is required (KVH part
no. 72-0908).
IMPORTANT!
These instructions assume you will connect to
the 79°W satellite (Sky Mexico 1) for service
and are not applicable for service obtained
through the 58°W satellite.
Connecting 1 Receiver
Connect an RF cable from the "Receiver" jack on
the TV-Hub to the "Satellite In" jack on the
receiver (see Figure 27).
Connecting Up to 4 Receivers
a. Connect an RF cable from the "Receiver" jack
on the TV-Hub to the "13V" input jack on a
multiswitch (see Figure 28). KVH offers a
4-output passive multiswitch (KVH part no.
72-0676).
b. Using four RF cables, connect four
multiswitch output jacks to the four "LNB"
input jacks on a Sky Mexico Pairing Bridge
(only available from authorized Sky Mexico
dealers).
c. Connect each receiver's "Satellite In" jack to
an available "STB" output jack on the pairing
bridge.
Wire the Receivers
Figure 39: Wiring 1 Sky Mexico Receiver
TV-Hub
POWER
MAX CURRENT 9.5A
Figure 40: Wiring 1 to 4 Sky Mexico Receivers
TV-Hub
Wi-Fi
10-30V
MAX CURRENT 9.5A
POWER
18V
Multiswitch
Output Jacks
LNB 1
LNB 2
Satellite In
Satellite In
Satellite In
Satellite In
RF1
Receiver
FUSE
Wi-Fi
DSWM
NMEA 2000
ETHERNET
DC IN
LEN=1
10-30V
ANTENNA
RECEIVER
NMEA 0183
Antenna
GROUND
B
A
RESET
Satellite In
AC Power
FUSE
Receiver
DSWM
NMEA 2000
ETHERNET
DC IN
LEN=1
ANTENNA
RECEIVER
NMEA 0183
GROUND
B
A
RESET
13V
13V
LNB 3
LNB 4
STB 1
Receiver
Receiver
Receiver
Receiver
Receiver
LNB 1
LNB 2
LNB 3 LNB 4
Pairing Bridge
STB 1 STB 2
STB 3 STB 4
STB 3
STB 2
STB 4
25
Advertisement
Table of Contents
