2.3.3 Connecting the Receiver Ground Wire
A grounding wire (Cable #32-0583-50) has been provided to
connect your receiver to a suitable ground and protect the
system. Attach the grounding wire to any suitable screw on the
rear panel of the receiver with a good contact with the receiver
chassis. The other end should be connected to a suitable ground.
2.3.4 Installing the Switchplate
After completing the switchplate wiring process, you must install
the switchplate itself. This process, detailed in the following
steps, is illustrated in Figure 2-13.
Figure 2-13 Mounting the Switchplate
A. Panel Cutout
.82"
(97 mm)
2. 6"
(60 mm) 2.05"
(52 mm)
.19"
(81 mm)
1. Fit the switchplate assembly and support frame
into the panel cutout made in Step 2 of Section 2.3,
"Connecting System Components" on page 2-8 and
flush to the mounting surface.
2. Drill out four
5
settings in the switchplate support frame.
3. Drill four
3
⁄
" (2.5 mm) holes in the mounting
3 2
surface using the countersunk holes in the support
frame as the template. Secure the support frame
and switchplate assembly to the mounting surface
using four #6 self-cutting screws.
54-0157 Rev. J
B. Support Frame
/
" (2.5 mm)
2
⁄
" (4 mm) holes in the countersunk
3 2
C. Front Cover
/
" (4 mm)
5
2
Before securing the switchplate to
the mounting surface, be sure to
strain-relieve the wires connecting
to the switchplate connectors.
Several tie-wraps have been
provided to aid in strain-relieving
the wires.
Installation
2-11