Installing An Ip Autoswitch - KVH Industries TracVision RV1 Installation Manual

A

Installing an IP AutoSwitch

Follow these steps to add an IP AutoSwitch
(KVH part no. 72-0634) to each DISH Network
receiver you want to be able to control satellite
selection in Automatic satellite switching mode.
NOTE: A receiver connected directly to the TV-Hub's
"Receiver" jack can control satellite selection without
an IP AutoSwitch.
Inspect Parts
Follow these steps to inspect the kit contents.
a. Unpack the box and ensure it contains each of
the following items:
• 3 ft (1 m) Ethernet cable
• 2 ft (60 cm) RF cable
• Adhesive-backed Velcro strip
b. Carefully examine all of the supplied parts to
ensure nothing was damaged in shipment.
c. Locate the serial number on the bottom of the
IP AutoSwitch (see Figure 46) and record it
on the Installation Checklist (supplied in the
Welcome Kit) for future reference.
Choose a Mounting Location
Choose a mounting location that meets the
following requirements:
• Dry, well-ventilated, and away from heat
sources
• Provides a clear view of and easy access to
the Master Select button (see Figure 46)
• Provides adequate clearance for running the
cables and allows for service loops and strain
relief
• Within 2 ft (60 cm) of the associated receiver
in order to use the supplied cable
• Either a horizontal or vertical surface
Figure 45: IP AutoSwitch
Figure 46: Serial Number and Master Select Button
Serial Number
Appendix
Master Select Button
27