Technical Specification; Power Supply; Control Pcb; Mechanical - Pyronix STERLING 10 Installation Instructions Manual

12

TECHNICAL SPECIFICATION

12.1

Power supply

Mains input
Power input fuse
Low voltage output
PCB input
Fuses
Low voltage output Bell
Low voltage output AUX
Low voltage output 17a.c
Battery charge voltage
Rechargeable battery capacity
12.2

Control PCB

Current consumption
(day mode)
(set mode)
(alarm)
Auxiliary DC output supply
Extension Speaker load
Bell
Strobe
PGM 1
PGM 2
Alarm bell time
Zone type
Zone loop current
Zone activation resistance
Zone loop activation timer
Exit timer
Entry timer
12.3

Mechanical

Dimensions
Case material
Colour
Weight excluding battery
12.4

Environmental

Operating temperature
Storage temperature
12.5

Cleaning

DO NOT use strong detergents to clean this control panel. To remove any dirt or grime, wipe with a clean damp cloth
ONLY
Page 28
: F1 T250mAH ceramic
: 13.8 V d.c. fused.
800mA maximum available for external devices.
: 17V a.c.
: F1 1 amp quick blow F1AL (Glass)
: F2 1 amp quick blow F1AL (Glass)
: F3 2 amp quick blow F2AL (Glass)
: 13.7 V d.c.
: 12V sealed lead acid, 2.8 to 7 AH.
: 130mA.
: 130mA.
: 130mA.
: Regulated 13.8V d.c. for use with PIR, microwave and shock sensors.
: 16 to 32 Ohms.
: 500mA.
: 500mA.
: 500mA max.
: 100mA max.
: 2 to 20 minutes (software programmable).
: Normally closed loops which activate when opened or short circuit.
: 0.76 to 1.03mA.
: 2K Ohms (minimum).
: 0.35 seconds.
: 2 to 255 seconds.
: 2 to 255 seconds.
: 340 x 280 x 101 mm.
: Polymer.
: White.
: 2.6Kg.
: 0 to +40 0 C (+32 to +104
: -20 to +60 C (-4 to +140
0
0 F).
F).
0