Programmable Re-Sets; Service Timer; Keyswitch Set Configuration; Reseting The Non Volatile Memory (Nvm) To Factory Settings - Pyronix STERLING 10 Installation Instructions Manual

9.12.6 System Option 4.
Enter followed by
Key Keypad LED
1 Alarm
2 Tamper
3 P.A.
4 Fire
Press the key to accept changes.
9.12.7

Programmable Re-sets

Enter followed by a single digit
9.12.8

Service Timer

Enter followed by
Set/Unset Cycles
Per Day 30 Days
2
4
6
Enter for no service timer.
9.13

Keyswitch Set Configuration

Enter Enter a digit between 0 - 3.
Set A
Set B
Set C
Set D
9.14 Resetting the Non Volatile Memory (NVM) to Factory Settings
The panel may be programmed as Power up NVM reset or engineer code lock NVM reset.
Power Up NVM Reset
If the panel is configured by the engineer to allow the Power up to reset the NVM back to factory settings.
Locate the NVM reset pins on the PCB, using the link pin provided connect the two pins together. Power down the
system (mains and battery). Restore power and remove the link. The system is now back to factory default settings.
Engineer Code Lock NVM Reset
Enter the engineer mode. Open the panel cover, use the link supplied to connect the NVM reset pins together and enter
on the key pad. The system should bleep three times. The system is now back to factory default settings.
Rins136 Issue 9
- to toggle RKP LEDs
LED ON
Abort digi active high
Open digi active high
Service timer warning and
lockout system on expire
Anti-code reset enabled
-
- for the following Set/Unset cycles between service intervals.
Time Between Services
6 Months 12 Months
LED OFF
Abort digi active low
Open active low
Service timer warning on
expire if programmed with
function 27
Anti-code reset disabled
( = continuous re-setting)
Page 25