Digital Communicators; Programmable Outputs; Shock Sensors - Pyronix STERLING 10 Installation Instructions Manual

Led keypad
Hide thumbs Also See for STERLING 10:
Table of Contents

Advertisement

8.10

Digital Communicators

The Digital Communicators can be programmed to switch between 0 to 12V or 12 to 0V except the line fail
which is factory set for input to 0V.
8.11

Programmable Outputs

There are two programmable Outputs which are switched negative (-) to positive (+) or positive (+) to
negative (-) depending upon which System Option is programmed.
8.12

Shock Sensors

Up to 20 shock sensors wired in parallel, may be used with the Sterling10 panel. Only PGM 1 can be used for shock
sensor reset.
NOTE: Do Not use Programmable Output 2 for the shock sensors. If Programmable Output 2 is used, the
shock sensors will not reset after an alarm activation.
Page 20

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STERLING 10 and is the answer not in the manual?

Questions and answers

Table of Contents