Mira Event Installation, Operation, Maintenance Manual page 40

Flow knob
Cover
retaining
screw
40 40 40 40 40
Pump
assembly
'O' seals
Mixer assembly
Temperature
trim
Temperature
knob
Section 10
7.4. 7.4.
7.4. 7.4. 7.4. Separate pump assembly from
mixer assembly.
7.5. 7.5.
7.5. 7.5. 7.5. Refit in reverse order.
Note! Note! Note! Ensure that the 'O' seals Note! Note!
between the mixer assembly and
the pump assembly are correctly
each each
seated on each each each male spigot.
Tip! Tip! Tip! Tip! When refitting the pump Tip!
assembly lightly grease 'O' seals
with a silicone based lubricant.
7.6 7.6 7.6. Restore the water supplies and
7.6 7.6
check for any leaks.
7.7. 7.7.
7.7. 7.7. 7.7. Refit the cover by locating the
cover onto the tongue on the top
of the case. Push the bottom of
the cover against the case,
tighten the cover retaining screw,
refit the flow knob, temperature
trim and temperature knob.
7.8. 7.8. 7.8. Prime the pump, refer to
7.8. 7.8.
"Commissioning: Priming the "Commissioning: Priming the
"Commissioning: Priming the "Commissioning: Priming the "Commissioning: Priming the
Appliance" Appliance" Appliance". Appliance" Appliance"
7.9. 7.9.
7.9. 7.9. 7.9. Restore the electrical supplies.