Table of Contents
Advertisement
Section
10
1. General
1. General
1. General
1. General
1. General
Each Mira Event is precision engineered to provide satisfactory performance provided
it is installed and operated in accordance with our recommendations contained in
section entitled "Installation Notes"
"Installation Notes"
"Installation Notes"
"Installation Notes".
"Installation Notes"
2. Cleaning
2. Cleaning
2. Cleaning
2. Cleaning
2. Cleaning
Many household cleaners contain abrasives and chemical substances, and should
not be used for cleaning plated or plastic fittings. These finishes should be cleaned
with a mild washing up detergent or soap solution, and then wiped dry using a soft
cloth.
3. 3. 3. 3. 3. Inlet Filters
Inlet Filters
Inlet Filters
Inlet Filters, Cleaning or
Inlet Filters
The following procedure can be applied for cleaning or renewing the inlet filters or inlet
filter 'O' seals.
Warning!
Warning!
Warning!
Warning!
Warning!
Isolate the electrical and water supply to the appliance before proceeding.
Turn flow control on and off to relieve water pressure.
Flow knob
Cover
retaining
screw
Inlet filter cap
32
32
32
32
32
Maintenance
Maintenance
Maintenance
Maintenance
Maintenance
, Cleaning or
, Cleaning or 'O'
, Cleaning or
, Cleaning or
Temperature
trim
Temperature
knob
'O'
'O' Seals Rene
'O'
Seals Renew w w w w al al al al al
Seals Rene
Seals Rene
'O'
Seals Rene
3.1.
3.1.
3.1.
Use the push-fit release tool to
3.1.
3.1.
lever off the temperature knob,
temperature trim and flow knob.
Unscrew the cover retaining screw
and remove the cover by pulling
the bottom of the cover in an
outward and upward direction.
3.2.
3.2.
3.2.
3.2.
3.2.
Remove the inlet filter cap
retaining screw and filter cap.
Section 10
Advertisement
Table of Contents
