Mira Event Installation, Operation, Maintenance Manual page 19

Chamfer
1.9. 1.9. 1.9.
1.9. 1.9.
supply pipework is cut squarely
and free from burrs
damage the inlet manifold seals.
Chamfer the end of the pipe to
assist insertion into the fitting and
prevent tearing the 'O' seal.
Thoroughly flush the incoming Thoroughly flush the incoming Thoroughly flush the incoming
Thoroughly flush the incoming Thoroughly flush the incoming
hot and cold water supply hot and cold water supply
hot and cold water supply hot and cold water supply hot and cold water supply
pipes pipes pipes pipes (Bye-law 55). pipes
Note! Note! Note! If using chrome plated
Note! Note!
copper pipework then all traces
of chrome plate will need to be
removed from the connecting
surfaces. If the chrome is not
completely removed then the
inlet manifold collet will not grip
the supply pipe and under
pressure the pipes may be
forced out.
Do not Do not Do not use stainless steel piping. Do not Do not
Note! Note!
Note! Note! PTFE tape or liquid Note!
jointing is not
connection.
Section 6
Ensure that the end of the
free from burrs free from burrs free from burrs, which will free from burrs
not not
not required to assist not
19 19 19 19 19