Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REMOVE THE HARD DISK DRIVE
To ensure that you do not damage the hard disk drive, follow all electrostatic discharge and
hard disk drive precautions (see
1 Remove the imagePASS from the copier (see
As part of this step, you must disconnect the power cable. Do not proceed until you have
done so.
2 Open the imagePASS (see
3 Remove the 3 screws on the outside of the imagePASS that connect the hard disk drive to the
chassis. Lift the hard disk drive out of the chassis.
Set the screws aside so that you can replace them later.
4 Place the hard disk drive in an antistatic bag.
T
O INSTALL THE HARD DISK DRIVE
To ensure that you do not damage the hard disk drive, follow all electrostatic discharge and
hard disk drive precautions (see
1 Secure the hard disk drive to the chassis using the three screws that you removed earlier (see
page
19).
2 Firmly connect the hard disk drive cable and the SATA power cable to the hard disk drive.
Do not use the 4-pin power cable.
N
:
OTE
3If you installed a new hard disk drive, clear the CMOS (see
You must clear the CMOS after installing a new motherboard, CPU, DIMM, or hard disk
drive to ensure compatibility between the new component and the previous settings stored in
the BIOS.
4 Reassemble the unit and verify functionality (see
If you install a new hard disk drive, you must install system software (see
hard disk drive is shipped without system software.
page
10).
page
14).
page
15).
page
10).
page
To motherboard SATA1
To power supply
Hard disk drive
page
40).
17).
page
51). A spare
47
Advertisement
Table of Contents
