S
P
ERVICE
ROCEDURES
T
O REMOVE THE MOTHERBOARD BATTERY
When you handle electronic components, follow electrostatic discharge (ESD) precautions
(see
page
10).
1 Remove the imagePASS from the copier (see
As part of this step, you must disconnect the power cable. Do not proceed until you have
done so.
2 Open the imagePASS (see
3 Remove the copier interface board (see
4 Locate the motherboard battery and the metal clip that holds the battery in place.
5 Pull the metal clip away from the battery (see
Use caution. Excessive force may damage the clip.
6 Remove the battery from the socket and release the clip.
T
O INSTALL THE MOTHERBOARD BATTERY
When you handle electronic components, follow electrostatic discharge (ESD) precautions
(see
page
10).
1 Pull the metal clip away from the socket (see
Use caution. Excessive force may damage the clip.
2 Insert the battery in the socket with the positive (+) side facing up.
Make sure that the battery snaps into place and that the clip holds the battery securely in
place.
3 Reinstall the copier interface board (see
4 Reassemble the imagePASS and verify functionality (see
When the battery is removed, the time and date is cleared. You can set the time and date from
Configure > Server. For more information, see Configuration and Setup, which is part of the
user documentation set.
page
14).
page
15).
page
24).
page
page
32).
page
24).
32).
page
17).
33