Confer Plastics ROLLGUARD 7200 Assembly And Installation Manual page 2

Model #7200 "ROLLGUARD
Ladder must be attached to pool frame - do not use with inflatable pools
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Right Bridge
Stabilizer
Outside
Right Rail
(OR)
Outside
Left Rail
(OL)
If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferladders.com
Parts List
4 - Handrail
1 - Deck
1 - Left Bridge with lock assembly
1 - Right Bridge
2 - Stabilizer Rail
10 - Ladder Tread
Hardware Bag
4 - Plug
6 - #10 x 1-1/4" Self Tapping Screw
2 - 1/4 - 20 x 3-1/2" Bolt
1 - Instruction sheet
:
Helpful Hints
1). Assemble the ladder by laying it down on a smooth flat surface.
2). All ten treads are the same, but must be installed tab marked minus [-] into tread lock
opening marked minus [-] and tab marked plus [+] into tread lock opening marked
plus [+] on the rails. TREADS MUST NOT BLOCK THE ROLLGUARD
LOCATED ON THE INSIDE AND OUTSIDE RAILS.
3). The ROLLGUARD
4). Slide the ROLLGUARD
Rail
Inside Left Rail (IL)
1 - ROLLGUARD
1 - Outside Left Rail (OL)
1 - Outside Right Rail (OR)
1 - Inside Left Rail (IL)
1 - Inside Right (IR)
2 - 1/4" Flat Washer
4 - 1/4" Hex Nut
1 - Padlock
2 - 1/4 - 20 x 1" Bolt
® locking assembly is pre-installed on the left bridge.
® into track, grab handle first.
® " A-FRAME LADDER
Handrails
Deck
ROLLGUARD
Left Bridge
(behind the
ROLLGUARD
Tools Needed for Assembly
®
®
® )
Treads
Inside
Right Rail
(IR)
1 - Rubber Mallet
1 - Cordless Drill w/Phillips Driver
1 - Garden Hose
1 - 1/4" Drill Bit
1 - Phillips Screwdriver
1 - Pliers
® TRACKS