Advertisement
Quick Links
Dealer/Installer: Give manual to homeowner.
Installer: Read "Safe Installation" on page #2 and all instructions before beginning. For proper assembly and
installation, instructions must be followed completely.
Homeowner: Read "Safe Use" on back cover before using. Save these instructions.
Installation must comply with local codes and may require permits.
Ladder must be attached to pool frame - do not use with inflatable pools.
SWING UP SECTION OF LADDER MUST BE INSTALLED ON OUTSIDE OF POOL
ASSEMBLY, INSTALLATION AND USE MANUAL
Assembly video available online: www.conferplastics.com
The Anti-Entrapment Barrier is included in this ladder for the U.S. and Canada only, as required by ANSI/APSP requirements.
The Anti-Entrapment Barrier is NOT intended as a substitute for competent adult supervision.
If you would like to purchase the barrier, please visit our website at: www.conferladders.com
To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or
other serious injury or death:
MODEL #7100X
A-FRAME LADDER
Adjusts to fit pools 48" to 54"
WEIGHT LIMIT 300 LBS.
Proudly Made in U.S.A. by
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Confer Plastics 7100X
Summary of Contents for Confer Plastics 7100X
- Page 1 Homeowner: Read "Safe Use" on back cover before using. Save these instructions. Installation must comply with local codes and may require permits. MODEL #7100X A-FRAME LADDER Adjusts to fit pools 48” to 54” Ladder must be attached to pool frame - do not use with inflatable pools.
-
Page 2: Safe Installation
LAK kit fits Confer A-frame ladders for use with non-traditional metal framed swimming pools with a wall height of 48” - 54”. Use with models: 7100b, 7100x, 7000x, 7000b, 7200 and 8100x. Not for use with inflatable pools. LAK KIT... - Page 3 Slip the four extension If the round boots over the ends of plastic inserts, the ladders legs. They on the sides will need to be all the of the exten- way on for most 52” sion boots, tall pools and backed are still in off one hole for 54”...
- Page 4 Making sure that the “swing-up” side of the platform is facing away from the “inside” ladder section, as shown, slip the openings of the platform over the upper ends of the ladder legs. Using a mallet or hammer tap the platform Slip the other two ladder legs down until it is fully seated onto the “nubs”...
- Page 5 If Ladder did not include Barrier, skip step 21. Continue to step 22. Fingers Large Small Barrier Barrier Lay ladder on its side, put a little liquid soap onto the square ends of the treads. Next place the tread connector onto the Separate Barrier sections at the top ends of the treads and strike hard with slightly and position Upper Brace over...
- Page 6 To reinstall, see Step #22. CONFER PLASTICS INC. FIVE YEAR WARRANTY Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from defects in workmanship for five years from date of purchase. DO NOT RETURN DEFECTIVE PART TO DEALER E-MAIL CONFER PLASTICS AT: LADDERS@CONFERPLASTICS.COM...
Need help?
Do you have a question about the 7100X and is the answer not in the manual?
Questions and answers