Confer Plastics 6000 Quick Start Manual

Retro fit barrier kit, barrier kit for ladder

Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100

Parts List

4 - #10 x 1-1/4" Sheet Metal Screw

1 – Upper Brace

1 – Lower Base

1 – Small Barrier Section

1 – Large Barrier Section

1 – Strip of 4 Foam Pads

Ladder must be assembled according to Instructions before installing Barrier Kit. Ladder must be

removed from Swimming Pool before installing Barrier Kit.

1. Snap Small and Large Barrier Sections into slots

on Lower Base as shown.

2. Separate Barrier sections at the top slightly and position Upper Brace over Small Barrier

Section. Next, spread the "fingers" on the Upper Brace and slide into position on the Large

Barrier Section.

Retro Fit Barrier Kit

See other side

Table of Contents

Do you have a question about the 6000 and is the answer not in the manual?

Page 1 Retro Fit Barrier Kit Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100 Parts List 4 - #10 x 1-1/4” Sheet Metal Screw 1 – Upper Brace 1 – Lower Base 1 – Small Barrier Section 1 – Large Barrier Section 1 –...
Page 2 Retro Fit Barrier Kit Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100 3. Place the Base and Brace into position, centered, on the bottom and fourth treads of the ladder. Install the 4 #10 x 1-14 screws on a slight angle as shown, first in the Upper Brace, and then in the Lower Base.

610070007100