Confer Plastics ROLL-GUARD 7200 Assembly And Installation Manual
A-frame ladder for rigid-framed pools only
Hide thumbs
Also See for ROLL-GUARD 7200:
- Assembly, installation and use manual (8 pages) ,
- Assembly and installation manual (8 pages) ,
- Assembly, installation and use manual (16 pages)
Related Manuals for Confer Plastics ROLL-GUARD 7200
Summary of Contents for Confer Plastics ROLL-GUARD 7200
- Page 1 SAVE THESE INSTRUCTIONS DEALER/INSTALLER: GIVE TO HOMEOWNER MODEL #7200 PATENTS PENDING “ROLL-GUARD” A-FRAME LADDER FOR RIGID-FRAMED POOLS ONLY ASSEMBLY AND INSTALLATION MANUAL Proudly Made in U.S.A. by...
- Page 2 Model #7200 “ROLL-GUARD” A-FRAME LADDER For Rigid-Framed Above Ground Pools ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY Handrails Deck Roll-guard Right Bridge Left Bridge Adjustable Brace Treads Outside Inside Right Rail Right Rail (OR) (IR) Outside Left Rail (OL) Inside Left Rail (IL) If missing parts call - Toll free U.S./Canada - 866-396-2968 or www.conferladders.com Parts List...
- Page 3 STEP 1: Tools needed: rubber mallet Parts needed: 1- Inside left rail (marked “IL” at the top) 1- Inside right rail (marked “IR” at the top) INSIDE LADDER 4- Ladder treads #2: Correct, tap down #1: Lay “IL” rail on flat surface. Incorrect, do not until seated, note track is block track.
- Page 4 STEP 2: Tools needed: rubber mallet Parts needed: 1- Outside left rail (marked “OL” at the top) 1- Outside right rail (marked “OR” at the top) OUTSIDE LADDER 5- Ladder treads #2: Correct, tap down #1: Lay “OL” rail on flat surface. Incorrect, do not until seated, note track is block track.
- Page 5 STEP 3: Tools needed: rubber mallet, cordless drill w/Phillips driver Parts needed: 1- Deck 4- Handrails HANDRAILS/DECK 1- Left bridge with lock assembly 1- Right bridge 2- #10 x 1-1/4” self tapping screws #1-3: Push handrails up through bottom of deck leaving about 3” exposed. #4: Align the inside/outside #5-6: Partially slide deck down locking handrails onto rails with deck/handrail.
- Page 6 STEP 4: Tools needed: rubber mallet Parts needed: 1- Roll-guard 1- Ladder tread INSTALLING ROLL-GUARD #1: With the ladder laying on #2-6: Slide roll-guard around to other side of ladder. it’s side, slide the roll-guard into track, grab handle first. #7-8: Install bottom tread.
- Page 7 STEP 5: Tools needed: garden hose, cordless drill w/Phillips driver 1/4” drill bit, Phillips screwdriver, pliers Parts needed: 4- cap plugs PLACING LADDER IN POOL 2- adjustable braces 2- 1/4-20 x 3-1/2” bolts, washers and hex nuts 1- Padlock CHOOSE A LOCATION THAT IS LEVEL AND IN FULL VIEW. POOL MUST HAVE COMPETENT ADULT SUPERVISION AT ALL TIMES WHEN IN USE.
- Page 8 CONFER PLASTICS, INC. LIMITED, PRO-RATED WARRANTY Confer Plastics, Inc. warrants their swimming pool ladders to be free from defects in workmanship for one year from date of purchase. After the first year the cost to replace a part is as follows:...
Need help?
Do you have a question about the ROLL-GUARD 7200 and is the answer not in the manual?
Questions and answers