Electrical Specifications; Mains Supply - Agilent Technologies Cary 60 User Manual

Specifications

Electrical Specifications

Mains Supply

A standard 3.2 A/12 V plug pack is provided. Power cords are provided based on
the user's country requirements. Only the supplied power supply is to be used with
this equipment.
Table 1. System electrical specifications
System unit
Spectrophotometer
The maximum power consumption is 60 VA, 38 W, 130 BTU/hr.
The installation of electrical power supplies must comply with the rules and/or
regulations imposed by local authorities responsible for the supply of electrical
energy to the workplace.
WARNING
Shock Hazard
Danger of electrocution. Good electrical grounding is essential to avoid
potentially serious shock hazards. A 3-wire outlet with ground connection
must be provided for the Cary 60. Make certain that power outlets are earth-
grounded at the grounding pin.
All power supplies for the Cary 60 must be single-phase, AC voltage, three-wire
system (active, neutral, earth) and should be terminated at an appropriate power
outlet receptacle that is within reach of the power cord. For safety reasons, a
separate power outlet receptacle should be provided for each unit in the system.
The use of extension cords or outlet adaptors is not recommended.
If necessary, replace the power cord only with a cord equivalent to the one
specified above.
Agilent Cary 60 Spectrophotometer User's Guide
Required supply voltage
90-265 V AC
Frequency 47-63 Hz
17