Table of Contents
Advertisement
The repair is done when the Levelflex is lowered and with the side section in
a downward position, so the entire implement rests on the ground. Remember
to depressurise the cylinder before the hydraulic tubes are loosened.
Plate 24
5. Remove the tubes. (To avoid oil pollution of the ground during repair, it is
6. Remove bolts and nuts (A), where after the cylinder is free.
7. Mounting of a new cylinder is to be done in reverse order. Use self-
8. After the mounting, raise and lower the crackerboard a few times in order
Replacement of the set of packings
The repair is done when the Levelflex is resting on the ground and the side
sections are lowered. The repair can be done either with the Levelflex
mounted in the lift on the tractor or unfastened while standing on both support
legs. Remember to depressurise the cylinders before the hydraulic tubes are
loosened.
1. Remove the tubes. (To avoid pollution of the ground during repair, it is
2. Remove the split pins and the rivets, where after the cylinder is free.
3. Drain the cylinder of oil by moving the piston back and forth.
side 22
Levelflex 2000
recommended to pick up the oil in a tray).
tightening nuts and avoid tightening them too much, because the cylinder
eye must be able to turn around freely in the fork for the meshing of the
crackerboard.
to air the system. Be careful that the tubes are not squeezed and that
the connections are tight.
recommended to pick up the oil in a tray).
A
Advertisement
Table of Contents
