Table of Contents
Advertisement
Levelflex 2000
Scrapping
The first step of the scrapping is to remove the hydraulic tubes and pick up
the oil. Drain the cylinders of oil, where after the oil and the tubes should be
sent to destruction.
If necessary, dismantle the Levelflex to make it easier to handle. The shaft
with the rings is removed as described in the first part of the instruction 'Re-
placement of bearings, shafts and rings'.
Remove the side sections from the frame head by pulling out the shafts, which
the side sections are hinged around, so that the side sections are free.
The rings are made of cast iron and the tines of hardened steel. The frame is
made of ordinary black iron. All the iron of the machine can be sent to recy-
cling.
side 24
Advertisement
Table of Contents
