Solid Model W. Crosskillring; Hyd. Model W. 80 Cm Rings - DAL-BO Levelflex 2000 Manual

Solid model w. Crosskillring

Follow the points as described in the instructions to the 70 rings.
Plate 18
Notice the rotational direction of the drum rings. Alternation occurs between
the small and the large rings, where a washer closest to the bearings is fol-
lowed by a small ring. Remember the bushings underneath the large rings (see
also the introduction to the chapter on 'Repair').

Hyd. model w. 80 cm rings

Plate 19
1. Remove the bolts in the bearings, where after the frame head and the side
2. Remove the locking bolts and the lock washer, and then the rings outside
3. Unscrew the pointed screw in the bearings so the bearings can be pulled
4. Put together in reverse order. The locking bolts and the pointed screws
side 18
Levelflex 2000
section can be lifted off the rings and the shaft by use of the three-point
linkage or a crane.
the bearings can be pulled off the shaft.
off the shaft.
must be secured with Locktite (see also the introduction to the chapter on
'Repair').