Parameter View - Siemens SITRANS TH100 Operating Instructions Manual

Procedure
1. Use the
2. To switch to the parameter view, press the
7.1.2.3

Parameter view

Parameter view
The parameter view shows the parameters, parameter values and the wizards of the device.
①
②
③
④
Figure 7-5
For parameters with an associated unit, the parameter name and unit are displayed as
alternating values in
List of parameters on the display
The parameters are displayed with parameter ID and parameter name.
Depending on the parameter settings or the device version of your device, some parameters are
not visible.
Parame‐ Parameter name on
ter ID the display
01 TYPE INPUT 1
02 WIRING 1
03 WIRE RES 1
04 TYPE INPUT 2
05 WIRING 2
06 WIRE RES 2
07 PV MAPPING
08 UNITS
09 LOWER RANGE
10 UPPER RANGE
11 DAMPING
12 FUNCT SAFETY
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
Operating Instructions, 05/2020, A5E41864807-AB
and buttons to navigate in the measurement view.
Name and unit of the parameter (alternating)
Parameter value
Parameter ID
"EDIT" symbol (permanently enabled)
Example of parameter view
①
. Example: Lower range value in °C.
Meaning
Input type 1
Connection type for input 1
Wire resistance for connecting cable at Input 1
Input type 2
Connection type for input 2
Wire resistance for connecting cable at Input 2
Assignment of the primary variable
Set unit of the primary variable
Set the lower range value of the primary variable
Set upper range value of the primary variable
Damping value
Enable and disable Functional Safety
Operating (SITRANS TF)
button.
7.1 Local operation
109