Edit View - Siemens SITRANS TH100 Operating Instructions Manual

Operating (SITRANS TF)
7.1 Local operation
Parame‐ Parameter name on
ter ID the display
13 LOOP TEST
14 TRIM INPUT 1
15 TRIM INPUT 2
16 CHANGE PIN
17 PIN RECOVERY
18 USER PIN
19 MIN INPUT 1
20 MAX INPUT 1
21 MIN INPUT 2
22 MAX INPUT 2
23 MIN ETEMP
24 MAX ETEMP
25 BUTTON LOCK
The parameter ID is written after the parameter name in parentheses from here on out. Example:
Parameter "Damping value" [11].
Navigating in the parameter view
Requirement
The button lock is disabled.
Disabling button lock (Page 158)
Procedure
1. Use the
To navigate faster, keep the
After the last parameter, you jump to the first parameter, and vice versa.
2. To switch to edit view, press the
3. To return to the measurement view, press the
7.1.2.4

Edit view

You change the parameter values in the edit view. Wizards are available for specific parameters.
Parameter values
There are various parameter values:
• Enumerations (e.g. unit type)
• Numerical values (e.g. damping)
110
Meaning
Loop test
One-point calibration input 1
One-point calibration input 2
Change User PIN
PIN recovery
Enable and disable User PIN
Minimum measured peak value at Input 1
Maximum measured peak value at input 1
Minimum measured peak value at input 2
Maximum measured peak value at Input 2
Minimum transmitter electronics temperature
Maximum transmitter electronics temperature
Enable and disable button lock
or buttons to navigate within the parameters.
or
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
button pressed.
button.
button.
Operating Instructions, 05/2020, A5E41864807-AB