Commissioning Sitrans Tf320 Single Chamber Housing With Hart - Siemens SITRANS TH100 Operating Instructions Manual

Commissioning

8.10 Commissioning SITRANS TF320 single chamber housing with HART

Before you start, note the following safety notes:
• General safety notes (Page 27)
• Basic safety notes: Installing/mounting (Page 61)
• Basic safety notes: Connecting (Page 77)
• Basic safety notes: Commissioning (Page 117)
Read the entire device manual in order to achieve the optimum performance of the device.
Procedure
1. Mount the device.
Mounting the SITRANS TF single chamber housing (Page 69)
2. Connect the device.
Connecting the SITRANS TF320 single chamber housing (Page 88)
3. For devices with intrinsically safe protection type, use an isolating power supply that
corresponds to the requirements of the relevant type of protection.
4. Switch on the power supply.
Switching on the supply voltage (Page 128)
5. Wait for 10 seconds.
After this startup time, the device is operational.
6. Wait 5 minutes to get exact measured values.
7. If you want to change the factory settings, configure the device using the buttons (Page 105)
or the USB modem and SIPROM T.
Parameter assignment over device with display (Page 138) or
Commissioning the USB modem and SIPROM T (Page 129)
8. Lock the device.
Locking the SITRANS TF device (Page 173)
8.10 Commissioning SITRANS TF320 single chamber housing with HART
Condition
You have read the following safety instructions:
• General safety notes (Page 27)
• Basic safety notes: Installing/mounting (Page 61)
• Basic safety notes: Connecting (Page 77)
• Basic safety notes: Commissioning (Page 117)
Read the entire device manual in order to achieve the optimum performance of the device.
124
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
Operating Instructions, 05/2020, A5E41864807-AB