Table of Contents
Advertisement
OPERATION
4.
Check if the oil is sticking up to between marks H and L on
dipstick (G).
It is correct if the oil level is between marks H and L.
If the oil level is below mark L, add oil through oil filler port
(F).
5.
If the oil level is higher than mark H, decrease it to a prop-
er level according to the following procedure.
1)
Drain the excess engine oil through drain plug (P).
2)
Check the oil level again.
6.
If the oil level is proper, tighten the oil filler cap securely.
7.
Close the engine rear cover (1).
METHOD FOR CHECKING ELECTRIC WIRING
•
If fuses are frequently blown out or if there are traces of short-circuiting on the electric wiring, im-
mediately ask your Komatsu distributor to locate the cause of it and to perform the repair.
•
Keep the top surface of the battery clean and check the vent hole in the battery cap. If it is clogged
with dirt or dust, wash the battery cap with water to clear the vent hole.
NOTICE
Perform inspection for the piping of "battery", "starting motor", and "alternator" with extreme care.
•
Perform inspection to confirm that the fuses have no defect and their capacity is proper.
•
Perform inspection to confirm that there is no disconnection or trace of short-circuiting in the electric wiring
and no damage to the coating.
•
Perform inspection to confirm that there is no loose terminals, and tighten any loose parts if found.
•
Check if there is any accumulation of combustible material around the battery, and remove such combusti-
ble material.
METHOD FOR CHECKING FUEL LEVEL, ADDING FUEL
•
Fuel is highly flammable and dangerous.
Do not bring any open flame close.
•
When adding fuel, never spill the fuel or let it overflow.
This may cause fire.
•
If any fuel has spilled, wipe it up completely.
If fuel has spilled over soil or sand, remove that soil or sand.
MACHINE OPERATIONS AND CONTROLS
k
k
CAUTION
k
k
WARNING
WENAM00150
3-101
Advertisement
Chapters
Table of Contents
