Installation Instructions; Unpack The Air Conditioner; Prepare Air Conditioner For Installation - Whirlpool ACQ062MP0 Use And Care Manual

Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
INSTALLATION
INSTRUCTIONS

Unpack the Air Conditioner

WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.

Prepare Air Conditioner for Installation

Install side curtains
NOTE: Attach curtains to unit before placing unit in window.
1. Remove unit from packaging.
2. Locate provided bag of 6 screws.
3. Insert top and then bottom of right curtain housing in top and
bottom curtain guides on air conditioner.
Top view
1
1. Curtain housing
2. Curtain guides on air conditioner
4. Extend right curtain outward so you may insert a #8 x
5. While the right curtain is still extended, insert screw in the top
6. Slide the curtain housing into the guides as far as it will go.
7. Repeat above steps for the left curtain.
2
Bottom view
1
1. Curtain housing
2. Curtain guides on air conditioner
round-head screw through the middle hole of the curtain.
Using #8 x in. screw, screw curtain to middle hole in air
conditioner cabinet.
NOTE: This screw is required to correctly attach curtain (top
to bottom) to the air conditioner cabinet.
and bottom slots of the curtain. Using #8 x
screws, screw the curtain to the top and bottom holes in the
air conditioner cabinet.
2
in.
in. pan-head
5