Insert The Ntak09 Into The Main Cabinet; Connect The Cables - Nortel Meridian 1 Option 11C Manual

Insert the NTAK09 into the main cabinet

Insert the NTAK09 circuit card into slots 1-9 in the Main cabinet, or in slots
11-19, 21-29, 31-39, 41-49 of the first, second, third, and fourth IP Expansion
cabinets, respectively.
Check for available card slots in the base cabinet and print the configuration
record to determine which slots may be used. To do this, use PRT CFN in
LD 22.

Connect the cables

Connect the NTBK04 cable to the 50-pin amphenol below the card slot in
which the NTAK09 circuit card is installed. Connect the other end of the
cable to the CSU or DSX-1 cross connect.
The NTBK04 is twenty feet long. If additional distance is required, the
NT8D97AX fifty-foot extension is available up to a 600 foot maximum. The
only cable required to support the NTAK09 circuit card is the NTBK04.
If you require pinout information on the NTBK04 cable, refer to the Table 4
on page 25.
Table 4
DS-1 line interface pinout for NTBK04 cable
From 50-pin
MDF connector
pin 48
pin 23
pin 25
pin 49
pin 24
PRI Implementation
Signal
to DB-15
name
pin 1 T
pin 9 R
pin 2 FGND
pin 3 T1
pin 11 R1
Page 25 of 100
Description
transmit tip to
network
transmit ring to
network
frame ground
receive tip from
network
receive ring from
network
Option 11C 1.5 Mb DTI/PRI