Nortel Meridian 1 Option 11C Manual page 43

CEQU
DLOP
MODE
TMDI
YALM
TRSH
T1TE
LD 16 – Configure a DTI trunk route.
Prompt
REQ
TYPE
TKTP
YES
c dd ff
TRK
[YES] NO
DG2 (FDL)
0-15
(0), 1, 2
Response
NEW
CHG
RDB
COT
WAT
DTI Implementation
Changes to common equipment
Where :
• c is the DTI/PRI digital card number 1-9 (main
cabinet), 11-19 (IP expansion cabinet1), 21-29 (IP
expansion cabinet 2), 31-39 (IP expansion cabinet 3),
41-49 (IP expansion cabinet 4.)
• dd is the number of data calls allowed (0-24) on this
DTI (default 24)
• ff is the frame format used (D2,D3,D4,ESF) where
default is ESF
Select Digital Trunk Interface mode
Whether the card is a TMDI card.
Yellow alarm method — prompted only if the frame
format is ESF — Must match the far end.
Use FDL with ESF and use DG2 with non-ESF. If not
prompted then DG2 is set automatically.
The maintenance and threshold table to be used for this
DTI card, as configured in LD 73.
T1 Transmit Equalization (0=0-200 ft., 1=200-400 ft,
2=400-700 ft). Only for TMDI = YES.
Description
Add new data
Change existing data
Route data block
Create a trunk route
Central Office Trunk data block
WATS Trunk data block
Page 43 of 100
Option 11C 1.5 Mb DTI/PRI