Table of Contents
Advertisement
Rear Tail / Stop, Turn Signal And Backup
Lamps
1. Remove the two screws that pass through
the bed sheet metal.
Tail Lamp Screw Locations
2. Pull the outboard side of the lamp rearward
far enough to unsnap the two receptacles
on the outboard side of the lamp housing
from the two plastic snap post retainers in
the outer box side panel.
Pulling Out The Tail Lamp
3. Disconnect the wiring harness connectors
from the bulb socket.
4. Rotate the bulb socket counterclockwise a
quarter turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened bulb
life will result.
IN CASE OF EMERGENCY
6. Reverse the procedure to install the bulb
and housing.
Center High Mounted Stop Lamp (CHMSL)
With Cargo Lamp
1. Remove the two screws holding the
housing/lens to the body as shown.
CHMSL Mounting Screw Locations
251
6
Advertisement
Table of Contents
