Table of Contents
Advertisement
134
SAFETY
ESC Activation/Malfunction Indicator Light
And ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the ignition
is placed in the ON position. It should
go out with the engine running. If the "ESC
Activation/Malfunction Indicator Light" comes
on continuously with the engine running, a
malfunction has been detected in the ESC
system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater
than 30 mph (48 km/h), see an authorized
dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator
Light" (located in the instrument cluster) starts
to flash as soon as the tires lose traction and
the ESC system becomes active. The "ESC
Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC
Activation/Malfunction Indicator Light" begins
to flash during acceleration, ease up on the
accelerator and apply as little throttle as
possible. Be sure to adapt your speed and
driving to the prevailing road conditions.
NOTE:
The "ESC Activation/Malfunction Indicator
Light" and the "ESC Off Indicator Light" come
on momentarily each time the ignition is
placed in the ON position.
Each time the ignition is placed in the ON
position, the ESC system will be on even if it
was turned off previously.
The ESC system will make buzzing or clicking
sounds when it is active. This is normal; the
sounds will stop when ESC becomes inactive
following the maneuver that caused the ESC
activation.
The "ESC OFF Indicator Light"
indicates the customer has elected to
have the Electronic Stability Control
(ESC) in a reduced mode.
Hill Descent Control (HDC) — If Equipped
Hill Descent Control (HDC) is intended for low
speed off road driving while in 4L Range. HDC
maintains vehicle speed while descending hills
during various driving situations. HDC controls
vehicle speed by actively controlling the brakes.
HDC Has Three States:
1. Off (feature is not enabled and will not
activate)
2. Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application)
3. Active (feature is enabled and actively
controlling vehicle speed)
Enabling HDC
HDC is enabled by pushing the HDC switch, but
the following conditions must also be met to
enable HDC:
Driveline is in 4L Range
Vehicle speed is below 5 mph (8 km/h)
Parking brake is released
Driver door is closed
Advertisement
Table of Contents
