RAM 1500 CLASSIC 2020 Owner's Manual page 216

214 STARTING AND OPERATING
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear Camera
mode is exited and the navigation or audio
screen appears again.
When the vehicle is shifted out of REVERSE (with
Camera delay turned on), the rear Camera
image will be displayed for up to 10 seconds
after shifting out of REVERSE unless the forward
vehicle speed exceeds 8 mph (13 km/h), the
transmission is shifted into PARK or the ignition
is placed in the OFF position.
Whenever the Rear View Camera image is
activated through the "Backup Camera" button
in the "Controls" menu, a display timer for the
image is initiated. The image will continue to be
displayed until the display timer exceeds 10
seconds and the vehicle speed is above 8 mph
(13 km/h) or the touchscreen button "X" to
disable the display of the Rear View Camera
image is pressed.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will be
displayed continuously until deactivated via the
touchscreen button "X".
A touchscreen button "X" to disable display of
the camera image is made available when the
vehicle is not in REVERSE gear.
When enabled, active guide lines are overlaid
on the image to illustrate the width of the
vehicle and its projected backup path based on
the steering wheel position. The active guide
lines will show separate zones that will help
indicate the distance to the rear of the vehicle.
NOTE:
For further information about how to access
and change the programmable features of the
ParkView Rear Backup Camera, refer to
"Uconnect Settings" in "Multimedia" for further
information.
The following table shows the approximate
distances for each zone:
Distance To The Rear
Zones
Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
1 ft - 6.5 ft
Yellow
(30 cm - 2m)
6.5 ft or greater
Green
(2 m or greater)
WARNING!
Drivers must be careful when backing up
even when using the ParkView Rear Back Up
Camera. Always check carefully behind your
vehicle, and be sure to check for pedestrians,
animals, other vehicles, obstructions, or blind
spots before backing up. You are responsible
for the safety of your surroundings and must
continue to pay attention while backing up.
Failure to do so can result in serious injury or
death.
CAUTION!
To avoid vehicle damage, ParkView should

only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must

be driven slowly when using ParkView to be
able to stop in time when an obstacle is
seen. It is recommended that the driver
look frequently over his/her shoulder when
using ParkView.