Table of Contents
Advertisement
250
IN CASE OF EMERGENCY
7. Reach into the front wheel house ahead of
the front wheel, remove the fastener, and
lift the cover over the access hole in the
front of the wheel house splash shield.
Access to the rear of the lamp can be gained
through this access hole.
8. Reach through the access hole of the wheel
house splash shield and lift the slide lock
upward far enough to disengage it from the
lock post on the back of the front lamp unit
housing.
Slide Lock
9. Remove the headlamp assembly. Grasp the
outboard edge of the lamp and pull it
straight forward to disengage the ball stud
from the plastic grommet.
10. Disconnect the wiring harness connectors
from the bulb socket.
11. Replace bulb(s) as necessary.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened
bulb life will result.
Always use the correct bulb size and type
for replacement. An incorrect bulb size or
type may overheat and cause damage to
the lamp, the bulb socket, or the lamp
wiring.
NOTE:
There are access covers over both headlamp
bulb access holes in the quad front lamp unit
housing (if equipped). These covers MUST be
reinstalled after the bulb has been replaced.
Fog Lamps — If Equipped
1. Reach under and behind the front bumper
to access the back of the front fog lamp
housing.
2. Disconnect the fog lamp wiring harness
connector from the fog lamp bulb.
3. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened bulb
life will result.
Advertisement
Table of Contents
