Remote Start Abort Message; To Enter Remote Start Mode; To Exit Remote Start Mode Without Driving; The Vehicle - RAM 1500 CLASSIC 2020 Owner's Manual

Remote Start Abort Message

The following messages will display in the
instrument cluster display if the vehicle fails to
remote start or exits remote start prematurely:
Remote Start Cancelled — Door Open

Remote Start Cancelled — Hood Open

Remote Start Cancelled — Fuel Low

Remote Start Cancelled — System Fault

Remote Start Disabled — Start Vehicle to

Reset
The instrument cluster display message stays
active until the ignition is placed in the ON/RUN
position.

To Enter Remote Start Mode

Push and release the Remote Start button on
the key fob twice within five seconds. The
parking lights will flash, vehicle doors will lock,
and the horn will chirp twice (if programmed).
Once the vehicle has started, the engine will run
for 15 minutes.
NOTE:
If your power door locks were unlocked,

Remote Start will automatically lock the
doors.
If an engine fault is present or fuel level is

low, the vehicle will start and then shut down
in 10 seconds.
The park lamps will turn on and remain on

during Remote Start mode.
For security, power window and power

sunroof operation (if equipped) are disabled
when the vehicle is in the Remote Start
mode.
The engine can be started two consecutive

times (two 15 minute cycles) with the key
fob. However, the ignition must be placed in
the ON/RUN position before you can repeat
the start sequence for a third cycle.
GETTING TO KNOW YOUR VEHICLE

To Exit Remote Start Mode Without Driving

The Vehicle

Push and release the remote start button one
time or allow the engine to run for the entire
15 minute cycle.
NOTE:
To avoid unintentional shutdowns, the system
will disable the remote start button for two
seconds after receiving a valid remote start
request.
To Exit Remote Start Mode And Drive The
Vehicle
Before the end of the 15 minute cycle, push and
release the unlock button on the key fob to
unlock the doors and disarm the vehicle
security alarm system (if equipped). Then, prior
to the end of the 15 minute cycle, place the
ignition in the ON/RUN position.
17
2