Subscribe to Our Youtube Channel
Related Manuals for Barco Lamp House with 2.5 kW lamp
Summary of Contents for Barco Lamp House with 2.5 kW lamp
- Page 1 Lamp House with 2.5 kW lamp Installation manual For HDX series R9864130 R5905109/02 21/09/2011...
- Page 2 Barco nv Events Noordlaan 5, B-8520 Kuurne Phone: +32 56.36.82.11 Fax: +32 56.36.88.24 Support: www.barco.com/esupport Visit us at the web: www.barco.com Printed in Belgium...
- Page 3 Changes Barco provides this manual ’as is’ without warranty of any kind, either expressed or implied, including but not limited to the implied war- ranties or merchantability and fitness for a particular purpose. Barco may make improvements and/or changes to the product(s) and/or the program(s) described in this publication at any time without notice.
-
Page 5: Table Of Contents
1. Lamp House with 2.5 kW lamp .............. - Page 6 Table of contents R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011...
-
Page 7: Lamp House With 2.5 Kw Lamp
1. LAMP HOUSE WITH 2.5 KW LAMP Purpose of the Lamp House with 2.5 kW lamp The Lamp House with 2.5 kW lamp is exclusively designed for the Barco HDX series and can thus not be used on any other equip- ment. - Page 8 1. Lamp House with 2.5 kW lamp AUTION Always wear a wrist band which is connected to the ground while handling the electrostatic dis- charge (ESD) sensitive parts. R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011...
-
Page 9: Lamp And Lamp House
• Realignment of the lamp in the Lamp House Removal of the Lamp House ARNING The procedures below may only be performed by Barco trained and qualified technicians. Necessary tools 7 mm flat screwdriver How to remove the Lamp House? 1. -
Page 10: Installation Of The Lamp House
Note: While starting up the projector, the electronics detect if a Lamp House is installed. If no Lamp House is installed, it is not possible to start up the projector. Installation of the Lamp House ARNING The procedures below may only be performed by Barco trained and qualified technicians. Necessary tools 7 mm flat screwdriver How to install the Lamp House? 1. -
Page 11: Realignment Of The Lamp In The Lamp House
Realignment of the lamp in the Lamp House ARNING The procedures below may only be performed by Barco trained and qualified technicians. It is recommended to realign the Z-axis of the lamp after the first run time of 100 and 200 hours. - Page 12 Do this for each direction and repeat this adjustment cycle minimum twice. 9. Tighten the lock nuts for the X-axis, Y-axis and Z-axis. R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011...
- Page 13 2. Lamp and Lamp House Image 2-9 X lock X adjustment Y lock Y adjustment Z lock Z adjustment 10.Switch off the projector. 11. Install the right projector cover. See the installation manual of the projector. R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011...
Need help?
Do you have a question about the Lamp House with 2.5 kW lamp and is the answer not in the manual?
Questions and answers