Advertisement
ISO DDIN radio provision
1. Cut the radio brackets at the scored line.
(Figure A)
2. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure B)
3. Locate the factory wiring harness and
antenna connector at the radio location
above the glove-box. Complete all
necessary connections to the radio.
Metra recommends using the proper
mating adapter from Metra and/
or Axxess. Test the radio for proper
operation.
4. Slide the radio assembly into the dash,
then secure using (2) #8 x 1/2" Phillips
truss-head screws up top, and (2) #8 x
3/8" Phillips truss-head down below.
5. Clip the radio trim panel onto the
radio assembly.
6. Reassemble the dash in reverse
order of disassembly to complete the
installation.
6
KIT ASSEMBLY
Remove shaded area
(Figure A)
(Figure B)
1.800.221.0932
|
MetraOnline.com
Advertisement
