Page 1
• Double DIN radio provision KIT COMPONENTS A) Radio Housing • B) Pocket • C) Trim Plate • D) ISO Brackets • E) Double DIN Trim Plate • F) Double DIN Brackets * 86-9001 Head Unit Removal Tool • Flat Blade Screwdriver Or Panel Removal Tool Note: Two sets of the head unit removal tools are recommended for easier removal of factor head unit.
99-9105 AUDI A4 2000-2001 Disconnect the negative battery terminal to prevent an accidental short circuit. Insert Metra’s 86-9001 into the slots in the factory radio and pull the radio from the dash. (Figure A) Disconnect the wiring. Continue to kit assembly.
99-9105 DIN RADIO PROVISION WITH POCKET Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) Slide the aftermarket radio into the cage and secure. (Figure B) Snap the pocket into the Radio Housing until secure.
Slide the radio into the radio opening until the side clips engage. (Figure B) Snap the ISO Trim Plate into the Radio Housing. (Figure C) Snap the pocket into the radio housing. (Figure C) Continue to final assembly. 99-9105 KIT ASSEMBL Y...
99-9105 DOUBLE DIN RADIO PROVISION Cut and remove center divider from radio housing. (Figure A) Snap the Double DIN brackets to the inside edge of the radio housing. (Figure B) Slide the Double DIN radio into the Double DIN bracket/radio housing...
Dimmer ..Orange / White *NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer’s specifications.