Craftex CX Series User Manual page 17

have to loosen and/or remove the table
screws and washers to access the leveling
adjusters. See Figure 6 below.
Figure 6
NOTE:
Turn the adjustments clockwise to raise
table or counter‐clockwise to lower table.
Making these adjustments if required may
take a couple attempts.
A.) Using a flat head screw driver turn
the adjusters to level the outfeed
table with the cutterhead.
B.) Once the table is parallel you may
then replace the washers and
tighten the screws back up.
4. Raise the infeed table so that it just
touches the straight edge form at
the front.
cutterhead with the 4mm hex
wrench so the first cutter tip is at it's
Now rotate the
highest point. Repeat this process
moving the straight edge towards
the fence. If the infeed table is not
parallel to the cutterhead or
coplanar to the outfeed table you
will need to perform the table
leveling instructions in the previous
step. See Figure 7 and Fiugure 8
showing both infeed and oufeed
tables are parallel and coplanar with
the cutterhead.
Figure 7
Figure 8
17