Maintenance.
•
Your EGR RollTrac is designed for years of Maintenance free operation, however in certain conditions
additional care may be required to ensure smooth operation. If the vehicle is driven in extreme condi-
tions (hot/cold/dust) then maintenance intervals will have to be reduced.
•
Regularly wash the cover, Only use mild detergents, liquid wax or general purpose cleaner' to clean
EGR RollTrac. Avoid the use of products containing alcohol as these can damage the painted surface.
•
Do Not use abrasive compounds on painted or plastic finished cover surfaces.
•
Only locks and lock recesses are to be lubricated with Graphite Powder.
DO NOT use any other lubricants or oils. Using alternative products will VOID Warranty.
•
It is recommended to check EGR RollTrac attachment clamps every 1000 km (more often in harsh
driving conditions).
Clamp bolt recommended torque settings are specified in your EGR RollTrac installation instruction.
If removed, bolts must have LOCTITE 243 re-applied and be re-tightened to specified values.
•
Regularly open inspection covers and remove any Debris from canister – hose with water to wash
debris from canister and ensure water flows freely from drain tubes.
•
Regularly inspect all four drain tubes for damage or splitting.
•
Regularly clean side rail seal, side rail glide strips and canister drive plates with water and mild deter-
gent.
•
If you notice Slow, Heavy or Noisy operation of the cover firstly clean the externals of the EGR RollTrac
(Slats, Side rails, Seals etc,) and the internals of the canister as described above. Allow product to dry
thoroughly. With service covers open and slats in fully closed position apply a coat of plastic compatible
100% liquid silicon spray to the spiral shaped internals of canister endplates ONLY. Open and close the
cover several times to ensure lubricant is dispersed over all moving parts. Reassemble Refit service
covers and recalibrate product if required. DO NOT use any other lubricants or oils. Using alternative
products will VOID Warranty.
Warranty Terms.
This warranty only applies to the original purchaser and is non-transferable. Warranty must be claimed
with original sales receipt for proof of purchase. EGR warrants that the EGR RollTrac will be free from
defects in material and workmanship for a period of
ranty claims are to be lodged via place of purchase.
Exclusions:
This warranty does not cover failure due to neglect, improper installation, including any modifications to
installation hardware, alterations, addition of non genuine equipment, abuse, accident, normal wear and
tear, lack of maintenance, misuse, and exposure to chemicals that are not safe for plastics or hardware
components.
Incidental or consequential damage or loss of contents due to use, neglect, lack of maintenance, misuse
of EGR RollTrac is sole responsibility of the vehicle owner and operator. Paint wear and panel damage
due to (clamping / installation) on the vehicle bed can happen with EGR RollTrac and is the sole responsi-
bility of the vehicle owner. Paint and panel damage to your vehicle is not covered under this warranty.
Disclaimer:
In the event that your EGR RollTrac is found to be defective under the terms of this warranty, it is at the
discretion of EGR to repair or replace the defective part. Transportation costs and fitment labour are not
associated with this warranty claim.
RT0001 Date: 08/04/20
Issue: 5
Page: 4 of 12
three (3)
years from the retail date of purchase. War-
Need help?
Do you have a question about the RollTrac and is the answer not in the manual?