Table of Contents
Advertisement
q u i c k s t a r t g u i d e
Caution!
This method of power shut-off is not recommended and should only be used in an
emergency.
To restart the system after an emergency shut-off:
• Rotate the Emergency OFF button clockwise to reset it, then press the ON button. For the
location of the Power On button, see the Power Up section in the chapter, SLA System Hardware.
Control Panel Laser LED
An LED light displays the current status of the laser (on/off). For more information see the
Control Panel section in the chapter, SLA System Hardware.
ID/Certification Labels
A label on the Viper Pro certifies laser safety conformance to the Code of Federal Regulations
(CFR). This label also gives power and ID information. This label is on the front door in the upper
right corner of the Viper Pro.
Safety Warning Labels
On the Viper SLA system, labels are affixed on the frame behind the vat door and near the
aperture at the top of the process chamber. These labels conform to the requirements for Class IIIb
and Class IV lasers. Refer to Figures 26, 27, 28, and 29 for their locations.
Xx: The previously-mentioned figures are on pp. 70-73 of the hardware manual. We need digital
pics.
55
s a f e t y
Advertisement
Table of Contents
