3D Systems Viper Pro SLA iPro 8000 Quick Start Manual page 17

q u i c k s t a r t g u i d e
Figure 1. Locking Pin
5 xx: Include a picture with callouts of the RDM? Show software.
6 Once the RDM is in the machine, connect the cables. There are two black power cords--the
heater and the RDM I/O connector. Plug the three-pronged power cord into the outlet and
place the connector into the top of the keys. (See Figure 2., "Open I/O Connector," on page 18
and Figure 3., "I/O Connector with Cable," on page 18.) When properly placed, the connector
lines up with the keys. You cannot install the I/O connector incorrectly.
17
r d m i n s t a l l a t i o n a n d r e m o v a l