Christie Crimson Series Technical Reference page 14

# Status
1 Combiner Hours
228 Diode current (Red1)
229 Diode current (Red2)
230 Diode current (Red3)
231 Diode current (Red4)
232 Diode current (Green
+Red A)
237
Diode current (Green
242
+Red B)
247
Diode current (Green
+Red C)
Diode Current (Blue)
251 Combiner TEC Current
252 Combiner Phosphor
Wheel
Crimson and Crimson Mirage Technical Reference–Status System
020-102661-04 Rev. 1 (07-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
State Value
Warming Up
Cooling Down
Overtemperature
Overcurrent Detected
Initialization Fault
Runtime Fault
<hours>:<minutes> (h:m)
Unknown
<current>mA
Unknown
Off
<current>mA
Unknown
Off
Detection Fault
<RPM>RPM
Crimson status system
Description
The combiner is in the process of turning
on.
The combiner is in the process of cooling
down.
The combiner has turned off due to the
thermal fuse being tripped.
The combiner has turned off due to over
current protection.
The combiner has turned off
unexpectedly during while the projector
is warming up/initializing..
The combiner has turned off
unexpectedly while in the projector is
on.
Displays the total amount of time that
the combiner has been on.
The combiner hours are unknown
because the combiner cannot be
communicated with.
Displays the current being drawn by the
diode(s).
Cannot retrieve the value due to a
communication error with the combiner
firmware.
The diode(s) is currently off.
Displays the current being drawn by the
thermal electric cooler (TEC).
Cannot retrieve the value due to a
communication error with the combiner
firmware.
The thermal electric cooler (TEC) is not
running.
Cannot detect a current. It appears the
TEC connector is unplugged.
Displays the phosphor wheel RPM.
14