Table of Contents
Advertisement
Chapter 1
Unpack and Install the Ex Analyzer Module
F
Items Delivered
Installation Site
F
Ambient Temperature
6
Installation
Follow
• the instructions and notes in the "Analyzer System Installation" chapter of
Operator's Manual 42/24-10 EN,
• the following special instructions and notes as well as
• the notes in the "Electrical Equipment in Explosion Hazard Zones" sections in
the Annex.
CAUTION!
The Ex analyzer module weighs approx. 26 kg! The following points should be
observed:
• Two persons are needed for unpacking and installation.
• The installation location must be stable and in order to support the Ex
analyzer module's weight.
Quantity Description
1
Ex analyzer module with attached connection cables for 24 VDC
power and system bus
1
Analyzer Data Sheet (in the central unit system housing)
1
Operator's Manual 42/24-10 EN
1
Operator's Manual 42/24-12 EN
1
2.5 mm Hex Wrench
1
220 mm diam. x 3 mm O-Ring
1
Emitter Wrench (only on Uras 14-Ex analyzer module)
The Ex analyzer module can be installed in Zone 1 and Zone 2 explosion hazard
areas (see the "Operating Specifications," section, Page 30)
The Ex analyzer module should not be mounted outdoors.
Conditions
Operation in compliance with sample-measuring data
Caldos 15-Ex, Caldos 17-Ex, Magnos 106-Ex
Uras 14-Ex
Operation without jeopardizing explosion protection
Caldos 15-Ex, Caldos 17-Ex, Magnos 106-Ex
Uras 14-Ex
Storage and shipping
Advance Optima Ex Analyzer Modules Operator's Manual
Temperature Range
+5 to +50°C
+5 to +45°C
–20 to +50°C
–20 to +45°C
–25 to +65°C
Continued on next page
42/24-12-2 EN
Advertisement
Table of Contents
